Holy crap. YOU MADE that tiny bolt?! Yikes. You'll have tiny robots running all over the place in no time...
Keep up the good work. Tedious stuff like that is so zen.
Yup! I made this part in about two hours on my mill/lathe setup. I think the harder part will be trying to make the nut that goes on it!
This page contains a single entry by Aruna published on April 29, 2010 10:18 PM.
It's the roodoo that you do. was the previous entry in this blog.
Health in VFX and friends is the next entry in this blog.
Find recent content on the main index or look in the archives to find all content.
Holy crap. YOU MADE that tiny bolt?! Yikes. You'll have tiny robots running all over the place in no time...
Keep up the good work. Tedious stuff like that is so zen.
LD
May 1, 2010 1:26 AM
Yup! I made this part in about two hours on my mill/lathe setup. I think the harder part will be trying to make the nut that goes on it!
Aruna
May 4, 2010 4:17 PM